GATEWAY H57H AM2 MOTHERBOARD MANUAL HOW TO

The pins are fine, on my I'll use those sections in future - I took the Forum headings too literally but I can look under the clamp as you suggest. I don't have the kit to remove/change CPU sockets - Yet. There are 4 header pins right near the IT8721F but two of those pins connect to ground so that can't be what I need, and I couldn't find a datasheet nor any info in the motherboard yes I had wondered about the rust on the CPU clamp I assume I can use an exterrnal SPI programmer but how do I connect that? I found some tutorials for that on youtube but from what that taught me i need to know where to connect CS, MOSI, MISO and SCLK.

GATEWAY H57H AM2 MOTHERBOARD MANUAL HOW TO

I did wonder if this is a BIOS problem as I have seen boards powering up but acting 'dead' with a corrupted BIOS, but I don't know how to program the BIOS as it appears to be embedded in the Super IO chip IT8721F. I don't have another LGA1156 CPU or motherboard here at the moment to prove if the CPU is any good The first figure is with no CPU fitted and the second is with the i5 CPU

The attached image shows what voltages I am getting. What I have found is that the CPU voltage seems unusually low (unless I just need more experience to determine that is true) Also the CPU does not get warm with the heatsink fitted and without the heatsink it just heats up very slowly

The board is basically dead - the fan spins but it doesn't beep or POST (00 on post diagnostic card), testing just with a bare board+CPU I have this H57H-AM2 V2.0 motherboard here, I'm trying to fix it to improve my own knowledge.

Gateway h57h-am2 motherboard manual